ASE Automobile & Light Truck (A1–A8) — Practice Exam
A4 Wheels and tires: practice questions
Our ASE A1–A8 bank has 6 questions on this topic. Here are 5 of them with answers; the full mock exam draws from every topic, like the real one.
Question 1 · A4 Suspension & Steering
What does a tire's load index and speed rating indicate?
- The rim width only
- The maximum load and speed the tire can safely carry
- The tread depth
- The tire's age and the plant where it was made
Show the answer
B. The maximum load and speed the tire can safely carry — Replacement tires should meet or exceed the original ratings.
Question 2 · A4 Suspension & Steering
What must be done after rotating tires on a vehicle with direct TPMS?
- Replace the valve stems
- Nothing, ever
- Perform a TPMS relearn if the system requires it
- Re-align the vehicle and reset the steering angle sensor
Show the answer
C. Perform a TPMS relearn if the system requires it — Sensor positions may need to be relearned.
Question 3 · A4 Suspension & Steering
A vibration at highway speed that is felt in the steering wheel usually comes from what?
- An out-of-balance or out-of-round front tire or wheel
- Rear brake drag or a seized rear caliper on one side
- An exhaust leak
- A worn rear spring
Show the answer
A. An out-of-balance or out-of-round front tire or wheel — Vibration felt in the seat often comes from the rear.
Question 4 · A4 Suspension & Steering
Why should lug nuts be torqued in a star pattern?
- To seat the wheel evenly and avoid warping the rotor or hub
- To lock the TPMS sensor
- To save time
- To balance the tire and center the wheel on the hub pilot
Show the answer
A. To seat the wheel evenly and avoid warping the rotor or hub — Impact guns can over-tighten; finish with a torque wrench.
Question 5 · A4 Suspension & Steering
Cupped tire wear usually points to what?
- Worn shock absorbers or struts
- Overinflation
- Underinflation on that tire
- Incorrect toe
Show the answer
A. Worn shock absorbers or struts — Worn dampers let the tire bounce on the road.
More ASE A1–A8 topics
- A1 General engine diagnosis
- A1 Cylinder head and valve train
- A1 Engine block
- A1 Lubrication and cooling
- A1 Fuel, ignition, air and exhaust
- A2 Diagnosis
- A2 In-vehicle maintenance
- A2 Removal and overhaul
- A3 Clutch
- A3 Transmission
- A3 Transaxle
- A3 Driveshafts
- A3 Drive axle
- A3 Four-wheel drive
- A4 Steering
- A4 Suspension
- A4 Alignment
- A5 Hydraulic and power brakes
- A5 Drum brakes
- A5 Disc brakes
- A5 ABS, TCS and ESC
- A6 General electrical diagnosis
- A6 Battery and starting
- A6 Charging system
- A6 Lighting
- A6 Body electrical
- A7 HVAC and cooling diagnosis
- A7 Refrigeration components
- A7 Operating systems and controls
- A8 General diagnosis
- A8 Ignition
- A8 Fuel, air and exhaust
- A8 Emissions
- A8 Computerized controls