ASE Automobile & Light Truck (A1–A8) — Practice Exam
A6 Body electrical: practice questions
Our ASE A1–A8 bank has 15 questions on this topic. Here are 5 of them with answers; the full mock exam draws from every topic, like the real one.
Question 1 · A6 Electrical/Electronic Systems
What are the two wires of a CAN bus called?
- Signal and reference
- CAN high and CAN low
- Input and output
- Power and ground
Show the answer
B. CAN high and CAN low — They carry mirror-image signals to reduce interference.
Question 2 · A6 Electrical/Electronic Systems
What is a 'wake-up' circuit used for in a module network?
- Bringing modules out of sleep mode when needed
- Starting the engine remotely from the key fob at low battery voltage
- Charging the battery
- Testing the airbags
Show the answer
A. Bringing modules out of sleep mode when needed — A module that won't sleep can cause a parasitic draw.
Question 3 · A6 Electrical/Electronic Systems
How should a live (undeployed) airbag module be carried and set down?
- Face down on a bench to protect the trim cover from scratches
- With the trim side facing away from the body and set face up
- With the trim side against the chest
- By its wiring
Show the answer
B. With the trim side facing away from the body and set face up — This reduces injury risk if it deploys unexpectedly.
Question 4 · A6 Electrical/Electronic Systems
A power door lock works intermittently and the actuator is noisy. What is likely?
- A blown main fuse
- A bad BCM in every case
- A failing lock actuator
- A bad key fob battery only
Show the answer
C. A failing lock actuator — Check voltage at the actuator while operating the switch.
Question 5 · A6 Electrical/Electronic Systems
A key fob works only up close. What is the most common cause?
- A bad door lock actuator
- A weak fob battery
- A blown fuse
- A failed BCM
Show the answer
B. A weak fob battery — Replace the battery before deeper diagnosis.
More ASE A1–A8 topics
- A1 General engine diagnosis
- A1 Cylinder head and valve train
- A1 Engine block
- A1 Lubrication and cooling
- A1 Fuel, ignition, air and exhaust
- A2 Diagnosis
- A2 In-vehicle maintenance
- A2 Removal and overhaul
- A3 Clutch
- A3 Transmission
- A3 Transaxle
- A3 Driveshafts
- A3 Drive axle
- A3 Four-wheel drive
- A4 Steering
- A4 Suspension
- A4 Alignment
- A4 Wheels and tires
- A5 Hydraulic and power brakes
- A5 Drum brakes
- A5 Disc brakes
- A5 ABS, TCS and ESC
- A6 General electrical diagnosis
- A6 Battery and starting
- A6 Charging system
- A6 Lighting
- A7 HVAC and cooling diagnosis
- A7 Refrigeration components
- A7 Operating systems and controls
- A8 General diagnosis
- A8 Ignition
- A8 Fuel, air and exhaust
- A8 Emissions
- A8 Computerized controls